Frequently Asked Questions
PT Bio1 uses bacteria blends to completely digest and eliminate grease. PT-4 uses solvents to liquefy it and move it out of the system. PT-4 acts faster but does not completely digest the grease, it simply moves the grease out of the system.
What would cause damage to a Clog Buster?
The most common Clog Buster failures occur because it was inserted into the drain pipe improperly. Clog Busters must be fully inserted into the drain pipe and not into an 90 degree elbow, or Tee fitting. These fittings allow for uneven expansion and eventual failure.
How do I clean up a clobber spill?
Spills/Leak Control: Spill area should be isolated to avoid possible exposure, and remove all ignition sources.
For small spills; neutralize with soda ash or lime, then absorb with sand, clay or diatomaceous earth.
Dike large spills; collect into an acid resistant container if possible otherwise cautiously dilute and neutralize with soda ash or lime, then collect or sweep neutralized material into an acid safe container for proper disposal.
Wash the area with large amount of water.